Joined in 2023 
82 
63 About this deal
F-One uses all-natural ingredients, so you needn’t worry about synthetic damage or residue on your instrument. There’s no wax included and it’s also free of lemon, making it safe for all kinds of finishes. The natural oils work to clean as well as conditions, refreshing the wood and giving it silky-smooth playability. Most of the hardware can be cleaned using a microfiber cloth. Just wipe the cloth along the metal pieces until the grease has been mostly removed. Once you've done that, you can follow it up with a cue tip or paintbrush to get into the little grooves and crevices. Take care not to get any moisture near the electric components on your guitar.
This oil comes in a small, 60ml bottle with a slow-drip release. You don’t need to make any extra effort not to spill it all over the place. It’s pretty reasonably priced and one small bottle will last a long time. You probably know how hard olive oil is to get off your hands (without using soap and water, it’s nearly impossible to remove it all). So that olive oil is going to remain on your strings for a long time. While this may sound good (“I’ll never need to reapply!”), you really don’t want old olive oil clinging to your strings for an eternity. Cue tip: A cue tip can be used to reach those more detailed spots and get into the groves of the fretboard. You can moisten it a little; just don't get it too wet because you don't want to expose your fretboard to too much moisture. Letting water sit on steel strings can cause them to rust. And when that water is mixed with other oils intended to keep the water from evaporating, it’s a less than ideal scenario. As I’ve mentioned earlier, we also want to avoid using plant-based oils since they can go rancid over time…and that’s just gross. Verdict Before cleaning the body of your guitar, it's a good idea to place masking tape or painter's tape over the sound hole. Because the sound hole is unfinished, you don't want to get any unwanted materials inside that accidentally might damage it. You can also use a small balloon and blow it up while inside your guitar to fit the sound hole's diameter.petroleum distillates.” This means that any rags used to apply lemon oil need to air out in a well-ventilated area afterwards, otherwise they can spontaneously combust. Mineral oil is an alkaline oil distilled from petroleum. Alkaline substances are much safer to use on your guitar than acids, since they won’t try and eat through the finish. Verdict
It’s vintage guitars vs new guitars in our latest discussion on whether or not an older guitar sounds better than a new one, and why ... If the bridge is gunky, you can take it off of the guitar and clean the groves using a damp microfiber cloth or WD-40. Take care when using WD-40 to apply it to the cloth first and then use a fresh cloth to wipe away any excess before replacing it on your guitar. How to Clean the Inside of Your Acoustic GuitarYou need specialised guitar polishor guitar cleaner as it doesn’t contain any harmful chemicals that will destroy or harm your finish or start to break down the tonewood. You can’t use regular furniture polish on guitars as they contain things like ammonia, abrasives and alcohol – all of which will damage your guitar. Secondly, where you live. If you live in a very arid, desert-like place you should undoubtedly use one of these products, as well as keep humidity levels at the correct level as much as possible. A well-maintained fretboard definitely makes the guitar nicer to play, and no doubt improves speed and playability, as well sustain. Does My Fretboard Need Oil? If you want to use an alternative to mineral oil, you can use fractionated coconut oil. This filtered version of coconut oil does not go rancid, and will work just as well as mineral oil at preventing fretboards from drying out.
This is probably the most important part of your guitar to clean frequently. The fretboard is the part of your guitar that gets subjected to the most wear and punishment, and excessive build-up of sweat and dust can cause permanent damage if you’re not careful. And only use dry chain lube. After a few minutes, dry lube is dry to the touch, but wet lube stays wet. If you were biking in wet conditions, this would be great, since the wet lube wouldn’t be washed off as easily by water, but you definitely don’t want your fingers covered in goop when you’re playing. Verdict For a satin or matte finish, you can simply take a microfiber cloth and wipe it down. With more stubborn grease and dirt, you can also use a small amount of dish soap with water and then apply a small amount to your cloth before wiping down the guitar's body. Don't apply any chemicals or cleaning products directly to the wood. No matter which product you choose, you will need to use only a small amount of it while oiling to avoid drowning wood. So with proper use, any of these products will last you for years. It is a good investment and your guitar will be thankful. How To Use Fretboard OilThe main difference lies in what kind of lemon oil fretboard solution we are talking about. At one end of the spectrum is the purest full-strength lemon oil, pressed directly from the peels of actual lemons, whose acidity levels will no doubt be through the roof. On the other end of the spectrum will be products with a far more diluted amount of lemon oil in the ingredients. Or in some instances with no lemon oil whatsoever, the name simply being used as a placeholder to grab the attention of the consumer and not much else. Pure Lemon Oil Fretboard Solution For the most part, cleaning an acoustic guitar is no different to cleaning an electric. You’re unlikely to find acoustic guitars with Maple fretboards, however the majority of them will feature either Rosewood or Ebony boards like their electric counterparts. This means that lemon oil will suffice; not only cleaning the material but rehydrating it too — giving it a new lease of life! When we play our guitar we transfer sweat and oil from our skin to the wood on our guitar or bass. Our skin and sweat is really bad for our guitar as it eventually starts to destroy the protective lacquer and eventually work its way into the wood, breaking it down. It happens slowly, but it does happen! Well, if you remember the last time you used a pencil (it’s been a while) you know how easily it gets all over your fingers. It also likes to stay there, and doesn’t wash off so well. So applying this to your strings may not be the best idea, since it will just come off on your fingers anyway. Verdict The Roche Thomas Bore will suit guitarists who require a nourishing liquid to maintain and encourage smoothness across the wood. It will be less suited to those looking for something protective against the grime.
You would think, seeing as you can buy this product in just about any guitar store you are likely to come across, and especially considering this product is specifically designed for this purpose, that there would only be one answer to this question, but you would be surprised. So, are Lemon Oil Fretboard Solutions Good or Bad? Cleaning the hardware on your guitar is something you also have to be fairly careful with. Metals are prone to corrosion, and the salts in sweat and skin oils can cause rust to develop over time. As an experienced luthier, my general rule is that I avoid the use of any materials or products on guitars I work on if I cannot guarantee a given outcome. I personally do favor using other oils more than lemon oil products on guitar fretboards.Well, this mantra doesn’t really apply to strings, but is WD-40 a good string lubricant alternative?
Great Deal 
New Comment